Iron Plates Bend When Stored: Causes and How to Avoid Them

Steel plates are an essential material in construction and fabrication work. However, in the field, it's not uncommon to find steel plates warping while still in storage, even before they're used. This can complicate the installation process and reduce the quality of the work.

Causes of Steel Plate Warping During Storage
1. Uneven Stacking
Steel plates stacked without a flat base or adequate support will experience uneven loading. Unbalanced pressure over a long period of time can cause the plates to warp.

2. Excessive Stacking Load
Stacking too many steel plates of varying thicknesses in a single stack can put excessive pressure on the plates below. This often leads to permanent deformation.

3. Storage on Damp Surfaces
Damp or unstable ground surfaces can affect the shape of steel plates. In addition to increasing the risk of rust, these conditions can also cause the plates to lose their shape.

4. Direct Exposure to Solar Heat
Steel plates stored in open areas and continuously exposed to the sun's heat can experience uneven expansion. This temperature difference can potentially cause the plates to deform.

5. Improper Handling
Lifting and moving metal plates without the proper tools can cause pressure or impact on one side of the plate, ultimately causing it to bend.

How to Avoid Bending Metal Plates
1. Use Level Bases and Supports
Store metal plates on pallets or support beams evenly spaced and positioned to distribute the load properly.

2. Arrange the Stacking System
Stack metal plates based on the same thickness and size. Avoid mixing thin and thick plates in one stack.

3. Store in a Dry and Protected Area
Choose a storage location that is dry, flat, and protected from rain and direct heat exposure.

4. Limit Stack Height
Maintaining a safe stack height will reduce excessive pressure on the plates at the bottom.

5. Use Appropriate Handling Equipment
Use a crane, forklift, or other standardized equipment to move metal plates to prevent uneven pressure.

Conclusion
Benting metal plates due to improper storage can cause various technical problems and cost a lot. With proper storage and handling systems, the shape and quality of steel plates can be maintained until they are ready for use in the field.

To avoid the risk of damaged materials from the outset, ensure you use steel plates from a trusted distributor with a good storage and handling system.
PT Intisumber Bajasakti (ISBS) provides quality steel plates with standardized quality control to support the smooth running of your project.

📞 Phone: 021-66675999
🌐 Web: intisumberbajasakti.com
✉️ Email: info@intisumberbajasakti.com

Contact the ISBS team now for a consultation on the right, strong, and ready-to-use steel plate for your project.

Back to List